HP 640n Print Server manual Snmp Test, Data Path Test, Select All Tests, Execution Time H, Execute

Table C-1HP Jetdirect EIO Menu on Graphical Control Panel (continued)

Menu item	Sub-menu item	Sub-menu item	Values and Description
		SNMP Test	Checks operation of SNMP communications by
			accessing predefined SNMP objects on the device.
			Yes: Select this test.
			No: Do not select this test.
		Data Path Test	Identify data path and corruption problems on an HP
			postscript level 3 emulation device. Sends a
			predefined PS file to the device. However, the file
			does not print (paperless).
			Yes: Select this test.
			No: Do not select this test.
		Select All Tests	Run all the embedded tests.
			Yes: Run all tests.
			No: Do not run all tests.
		Execution Time [H]	Specify the length of time (in hours) that an
			embedded test runs, using a value from 1 to 60. If you
			select zero (0), the test runs indefinitely until an error
			occurs or the device is turned off.
			Data gathered from the HTTP, SNMP, and Data Path
			tests is printed after the tests complete.
		Execute	No (default): Do not run the selected tests.
			Yes: Run the selected tests.
	Ping Test		Test network communications. Sends link-level
			packets to a remote network host, then waits for an
			appropriate response.
		Dest Type	Target device is an IPv4 or IPv6 node.
		Dest IPv4	The IPv4 address.
		Dest IPv6	The IPv6 address.
		Packet Size	Size of each packet, in bytes, sent to the remote host.
			The minimum is 64 (default) and the maximum is
			2048.
		Timeout	Length of time, in seconds, to wait for a response
			from the remote host. The default is 1 and the
			maximum is 100.
		Count	Number of ping test packets to send. Select a value
			from 1 to 100. Enter zero (0) to run the test
			continuously.
		Print Results	Print the test results (if not running continuously).
			Yes: Print the results.
			No (default): Do not print the results.

186 Appendix C HP Jetdirect control panel menus (V.45.xx.nn.xx) ENWW