TCP/IP Settings
The TCP/IP Settings menu provides access to the following tabs:
●Summary tab on page 74
●Network Identification tab on page 75
●TCP/IP(v4) tab on page 76
●TCP/IP(v6) tab on page 77
●Config Precedence tab on page 78
●Advanced tab on page 79
Summary tab
This tab provides a summary of the TCP/IP configuration. Items on this page are described in the following table.
Table 4-4 TCP/IP Summary tab
Item | Description |
|
|
Host Name | IP host name assigned to the device and stored on the HP Jetdirect print server. |
| To configure a host name, see the Network Identification tab. |
|
|
IPv4 Status | Status of the IPv4 protocol. You cannot disable IPv4 from the HP Embedded Web |
| Server in this release. |
|
|
Fully Qualified Domain Name | Consists of the device's host name and domain name. Unless the network |
(IPv4/IPv6) | administrator segments domains into separate IPv4 and IPv6 hosts, you can use the |
| FQDN on either IPv4 or IPv6 networks simultaneously. |
|
|
IPv4 Address | IPv4 address, subnet mask and default gateway for the print server. |
|
|
Config By | IPv4 parameters configured using: DHCP, BOOTP, Manual, or Auto IP. |
|
|
DHCP Lease Time | Duration of the DHCP IP address lease (in seconds) for the print server. Populated if |
| DHCP configuration is used. |
|
|
IPv6 Status | Status of the IPv6 protocol. Enable or disable using the HP Embedded Web Server. |
|
|
Fully Qualified Domain Name | Consists of the device's host name and domain name. Depending on the network |
(IPv6 only) | architecture, it can be the same as, or different from, the printer's IPv4 FQDN. If |
| assigned, it applies to the IPv6 network only. |
|
|
74 Chapter 4 HP Embedded Web Server (V.45.xx.nn.xx) | ENWW |