HP 640n Print Server manual Allow, TCP/IP Other, Syslog-svr

Table 3-3Telnet Commands and Parameters (continued)

allow	Add an entry into the host access list stored on the HP Jetdirect print server. Each entry
	specifies a host or network of hosts allowed to connect to the printer. The format is
	allow netnum [mask] where netnum is a network number or host IP address, and
	mask is an address mask of bits applied to the network number and host address to
	verify access. Add up to 10 access list entries. If there are no entries, all hosts are
	permitted access. The following are some example settings:
	allow 192.0.0.0 255.0.0.0 Allows hosts on network 192.
	allow 192.168.1.2 Allow a single host. The default mask 255.255.255.255 is
	assumed and is not required.
	allow 0 Clear the host access list.
	For additional information, see Security features (V.45.xx.nn.xx) on page 121.
TCP/IP Other
syslog-config	Allow syslog server operation on the print server (UDP port 514).
	0: Disable.
	1 (default): Enable.
syslog-svr	IPv4 address of the server that the HP Jetdirect server sends syslog messages to. For
	example:
	syslog-svr: 192.168.40.1
syslog-max	Maximum number of syslog messages the HP Jetdirect print server can send per
	minute.
	0: Disable. The number of syslog messages is not restricted.
	10 (default): Enable.
syslog-priority	Filter syslog messages sent to the syslog server. The filter range is from 0 to 7, with 0
	being the most specific and 7 the most general. Only messages that are lower than the
	specified filter level (or higher in priority) are reported.
	Set to 8 to disable all syslog messages.
	0: Disable.
	7 (default): Enable. Messages of all priorities are sent.
syslog-facility	Identify the source facility of a message. Typically used to identify the source of selected
	messages during troubleshooting. By default, the HP Jetdirect print server uses LPR as
	the source facility code. Use values of local0 through local7 to isolate individual or
	groups of print servers.
slp-config	Use the SLP operation on the print server. SLP is used by selected HP software
	applications (through UDP port 427) to automate device discovery.
	0: Disable.
	1 (default): Enable.
	If SLP uses multicast protocols, you must enable multicast IPv4.

50 Chapter 3 TCP/IP configuration ENWW