HP 640n Print Server manual 1000t-ms-conf, 1000t-pause-conf, Network-select

Table 3-3Telnet Commands and Parameters (continued)

1000t-ms-conf	Configure the print server as a master or slave device on a 1000T network.
	AUTO or 0 (default): Master/slave configuration is automatically sensed and assigned.
	MASTER or 1: Configure as a 1000T master device.
	SLAVE or 2: Configure as a 1000T slave device.
1000t-pause-conf	Control the flow of inbound and outbound data.
	OFF or 0 (default): Disable flow control.
	AUTO or 1: Configure through auto-negotiation with the network switch.
	RCV or 2: Enable only for data received from the network.
	TRANS or 3: Enable only for data transmitted to the network.
	TXRX or 4: Enable for both received and transmitted data.
network-select	(For HP Jetdirect products with a dual wired/wireless port. Specifies the active behavior
	of the print server.)
	● Auto (default): Automatically detects whether a network cable is attached. If a
	network cable is not attached, only the IEEE 802.11bgn wireless port is active. If a
	network cable is attached, then only the IEEE 802.3 wired port is active.
	CAUTION: Do not plug a network cable into an active wired/wireless port if the
	network-select command is set to Auto. Wireless access will immediately
	terminate.
	● Wired: Only the 802.3 wired port is active.
	● Wireless: Only the 802.11bgn wireless port is active.
link-type	(For wired 10/100/1000T Ethernet.) Set the print server's link speed (10, 100, 1000
	Mbps) and communication mode (Full- or Half-Duplex). The available link-speed
	depends on the print server model. Select from the following communication modes:
	AUTO (default): Use auto-negotiation to configure the highest link speed and
	communication mode allowed.
	1000FULL: 1000 Mbps, full-duplex operation.
	100AUTO: Limit auto-negotiation to a maximum link speed of 100 Mbps.
	100FULL: 100 Mbps, full-duplex operation.
	100HALF: 100 Mbps, half-duplex operation.
	10FULL: 10 Mbps, Full-duplex operation.
	10HALF: 10 Mbps, half-duplex operation.
hw-acclrn-conf	Use hardware acceleration.
	0: Disable.
	1 (default): Enable.

58 Chapter 3 TCP/IP configuration ENWW