HP 640n Print Server manual IP Address, Subnet Mask, Default Gateway, Config by

Table 8-7 IPv4 Section

Message	Description
STATUS	Current TCP/IPv4 status.
	READY Print server is awaiting data over TCP/IP.
	DISABLED TCP/IP is manually disabled.
	INITIALIZING Print server is searching for the BOOTP server, or trying to get the
	configuration file through TFTP. An additional status message can also be displayed.
	An error code and message is displayed if the print server is not ready. For more
	information, see Table 8-13 Error messages on page 153.
IP ADDRESS	IPv4 address assigned to the HP Jetdirect print server. This is a required entry for
	operation of the print server on a TCP/IP network. During initialization, a temporary
	value 0.0.0.0 is displayed. After two minutes, a default IP address 169.254/16 or
	192.0.0.192 is assigned.
	Not Specified IP address is not assigned or the value is zero.
SUBNET MASK	IPv4 subnet mask configured on the HP Jetdirect print server. During initialization, a
	temporary value 0.0.0.0 is displayed. Depending on configuration parameters, the
	print server can automatically assign a usable default value.
	Not Specified Subnet mask is not configured.
DEFAULT GATEWAY	IPv4 address of the gateway used when sending packets off the local network. Only
	one default gateway can be configured. During initialization, a temporary value
	0.0.0.0 is displayed. If not provided, the IP address of the HP Jetdirect print server is
	used.
	Not Specified Default gateway is not configured.
CONFIG BY:	Indicates how the HP Jetdirect print server obtained its IPv4 configuration:
	BOOTP Automatic configuration through a BOOTP server.
	BOOTP/TFTP Automatic configuration through a BOOTP server and TFTP
	configuration file.
	DHCP Automatic configuration through a DHCP server.
	DHCP/TFTP Automatic configuration through a DHCP server and TFTP configuration
	file.
	RARP Automatic configuration through the RARP.
	USER SPECIFIED Manual configuration through Telnet, the printer's control panel,
	HP Web Jetadmin, HP Embedded Web Server, or other method.
	DEFAULT IP Default IP address was assigned. This address might not be a valid
	address for your network.
	AUTO IP Link-local IP address (169.254.x.x) was assigned. If the network is a link-
	local network, this address should be valid.
	NOT CONFIGURED Not configured with IP parameters. Verify that TCP/IP is
	enabled, or check for error status.

148 Chapter 8 HP Jetdirect configuration pages ENWW