Henny Penny OFG-390 manual 303

			Model OFG- 390
4-2. ERROR CODES (Continued)		CE Only - Along with the error codes from page 4-2, CE
		units have the following self-diagnostic error codes:
DISPLAY	CAUSE		PANEL BOARD CORRECTION
“E10”	Highlimit		Reset the high limit by manually pushing up on the red reset
			button; if the high limit does not reset, the high limit must be
			replaced
“E15”	Drain switch		Close the drain, using the drain valve handle; if display still
			shows “E-15”, have the drain microswitch checked
“E-20A”	Air pressure		Press the timer button to try the ignition process again,
	switch failure		and if “E-20A” persists, call Henny Penny’s Service
	(stuck closed)		Department
“E-20 B”	Draft fan or		Press the timer button to try the ignition process again,
	air pressure		and if “E-20 B” persists, call Henny Penny’s Service
	switch failure		Department
	(stuck open)
“E-20 C”	Left gas module		Press the timer button to try the ignition process again, and if
	failure		“E-20 C” persists, call Henny Penny’s Service Department
“E20 D”	Rightmodule		Press the timer button to try the ignition process again, and if
	failure		“E-20 D”, persists, call Henny Penny’s Service Department
“E20 E”	Both modules		Press the timer button to try the ignition process again, and if
	failure		“E-20 E”, persists, call Henny Penny’s Service Department
“E20 F”	Left module		Press the timer button to try the ignition process again, and if
	no flame sense		“E-20 F”, persists, call Henny Penny’s Service Department
“E20 G”	Rightmodule		Press the timer button to try the ignition process again, and if
	no flame sense		“E-20 G”, persists, call Henny Penny’s Service Department
“E20 H”	Both modules		Press the timer button to try the ignition process again, and if
	no flame sense		“E-20 H”, persists, call Henny Penny’s Service Department

4-3 303