Henny Penny OFG-390 Filter Pump Motor, Protector-Manual, Reset, Regular Maintenance, Schedule

Page 35

 

 

Model OFG- 390

3-11.

CLEANING THE FRYPOT

5. Refer to KFC’s Standard’s Library on cleaning instructions.

 

(Continued)

 

 

 

If the cleaning solution in the frypot starts to foam and

 

 

boil over, immediately turn the POWER Switch to OFF

 

 

or damage to components could result.

 

 

Do not use steel wool, other abrasive cleaners or clean-

 

 

ers/sanitizers containing chlorine, bromine, iodine or

 

 

ammonia chemicals, as these will deteriorate the stainless

 

 

steel material and shorten the life of the unit.

 

 

Do not use a water jet (pressure sprayer) to clean the

 

 

unit, or component damage could result.

 

 

Make sure the inside of the frypot, the drain valve opening,

 

 

and all parts that come in contact with the new shortening are

 

 

as dry as possible.

3-12.

FILTER PUMP MOTOR

The filter pump motor is equipped with a manual reset button,

 

PROTECTOR-MANUAL

located on the rear of the motor, in case the motor overheats. If

 

RESET

motor won’t run, wait about 5 minutes before attempting to reset

 

 

this protective device to allow motor to cool. Remove the access

 

 

panel on the left side panel of the unit to reset the button. It takes

 

 

some effort to reset, and a screwdriver can be used to help reset

 

 

the button.

 

 

To prevent burns caused by splashing shortening, turn

 

 

the unit’s main power switch to the OFF position before

 

 

resetting the filter pump motor’s manual reset

 

 

protection device.

3-13. REGULAR MAINTENANCE

The Henny Penny open fryer does require care and proper mainte-

 

SCHEDULE

nance. The table below provides a summary of scheduled mainte-

 

 

nance. The following paragraphs provide step-by-step preventive

 

 

maintenance procedures to be performed by the operator.

Procedure

Frequency

Filtering of shortening

See KFC’s Standards Library

Checking/cleaning dilution box

Monthly-see Preventive Maint. Section

Cleaning the Nylatrons

Monthly-see Preventive Maint. Section

Changing of shortening

See KFC’s Standards Library

Cleaning blower

Annually-see Preventive Maint. Section

Changing the filter envelope

See KFC’s Standards Library

Cleaning the frypot

See KFC’s Standards Library

Lubricate lid rollers

Annually-see Preventive Maint. Section

810

3-13

Page 34 Page 36
Image 35
Page 34 Page 36
Contents OPERATOR’S Manual Page Limited Warranty for Henny Penny Equipment Keep appliance area free and clear from combustibles Datos Tecnicos Para Products CE Henny Penny Head GAS Open Fryer SpecificationsTable of Contents Assistance IntroductionProper Care Injury SafetyHazardous Situation WHICH, if not AVOIDED, will Result in Death or SeriousPage Unpacking Instructions InstallationStrapped to the pallet, under the fryer Remove the counterweights from the pallet, which areUnpacking InstructionsOptional Ramp Unloading Model OFG 908 Ment. Restraining ties may be used for stabilization Position and install fryer to prevent tipping or moveSelecting LocationGAS Supply Ventilation of FryerSystem at test pressures equal to or less than 1/2 During any pressure testing of the gas supply pipingFryer must be isolated from the gas supply piping System by closing its individual manual shutoff valveModel OFG 303 GAS Pressure Regulator SettingGAS Leak Test Requirements ElectricalModel OFG Page Operation Operating Components Spark Ignitors Airflow SwitchHigh Limit Ignition ModulesMelt Cycle SwitchesIndicators LID OperationING is HOT and will Cause Burns Switches IndicatorsAlthough the Displaywillread Cool During the Standby MODE, the ShortenSMS Controls Filling or Adding Shortening Basic Operation Cool With Prolonged USE, the Flashpoint Care ShorteningWhich could Result in Serious Burns Personal INJURY, FIRE, AND/OR PropertyFiltering of Shortening Turn COOK/PUMP switch to OFF positionTube is not Tightened PROPERLY. if SO Cloth or Glove When TighteningSHORTENING, IT’S Possible That the Filter Connection AT the Union on the FilterLightingand Shutdown of the Burners Cleaning the Frypot PROTECTOR-MANUAL ResetRegular Maintenance Filter Pump MotorLubricating Lid Rollers -Annually Preventive MaintenanceCleaning the Nylatrons Monthly Maintenanc PreventiveCode ProgrammingAfter the proportional control, press and release Review Usage Special Program ModeReset Usage ProgrammingSpeaker Frequency, Codes, Initialize System Factory Presets F/C, Gas/Electric, Speaker VolumeAppliance Test Tech I/O ModeMode Special ProgramHeat Control Problem Cause Correction Troubleshooting Trouble Shooting GuideDisplay Cause Panel Board Correction Error Codes303 O S S a R Y Model OFG Shortening level also referred to as fill lines Gas fryers only See ignition modules Henny Penny Corp., Eaton, Ohio 45320, Revised
Top Page Image Contents