Henny Penny OFG-390 manual Installation, Unpacking Instructions

Page 11

Model OFG- 390

	SECTION 2. INSTALLATION

2-1. INTRODUCTION	This section provides the installation and unpacking instructions for
	the Henny Penny OFG-390, open fryer.
	Installation of this unit should be performed only by a qualified
	service technician.

Do not puncture the unit with any objects such as drills or screws as component damage or electrical shock could result.

2-2. UNPACKING INSTRUCTIONS

Any shipping damage should be noted in the presence of the delivery agent and signed prior to his or her departure.

1.Cut and remove the metal bands from the carton.

2.Remove the carton lid and lift the main carton off the fryer.

3.Remove corner packing supports (4).

4.Cut the stretch film from around the carrier/rack box and remove it from the top of the fryer lid.

4.Cut and remove the metal bands holding the fryer to the pallet.

All counterweights must be loaded before unlatching the lid, or personal injury could result.

5.Remove the fryer from the pallet.

Take care when moving the fryer to prevent personal injury. The fryer weighs approximately 670 lbs. (304 kg).

803

2-1

Image 11

Contents OPERATOR’S Manual Page Limited Warranty for Henny Penny Equipment Keep appliance area free and clear from combustibles Datos Tecnicos Para Products CE Henny Penny Head GAS Open Fryer SpecificationsTable of Contents Assistance IntroductionProper Care Injury SafetyHazardous Situation WHICH, if not AVOIDED, will Result in Death or SeriousPage Unpacking Instructions InstallationStrapped to the pallet, under the fryer Remove the counterweights from the pallet, which areUnpacking InstructionsOptional Ramp Unloading Model OFG 908 Ment. Restraining ties may be used for stabilization Position and install fryer to prevent tipping or moveSelecting LocationGAS Supply Ventilation of FryerSystem at test pressures equal to or less than 1/2 During any pressure testing of the gas supply pipingFryer must be isolated from the gas supply piping System by closing its individual manual shutoff valveModel OFG 303 GAS Pressure Regulator SettingGAS Leak Test Requirements ElectricalModel OFG Page Operation Operating Components Spark Ignitors Airflow SwitchHigh Limit Ignition ModulesMelt Cycle SwitchesIndicators LID OperationING is HOT and will Cause Burns Switches IndicatorsAlthough the Displaywillread Cool During the Standby MODE, the ShortenSMS Controls Filling or Adding Shortening Basic Operation Cool With Prolonged USE, the Flashpoint Care ShorteningWhich could Result in Serious Burns Personal INJURY, FIRE, AND/OR PropertyFiltering of Shortening Turn COOK/PUMP switch to OFF positionTube is not Tightened PROPERLY. if SO Cloth or Glove When TighteningSHORTENING, IT’S Possible That the Filter Connection AT the Union on the FilterLightingand Shutdown of the Burners Cleaning the Frypot PROTECTOR-MANUAL ResetRegular Maintenance Filter Pump MotorLubricating Lid Rollers -Annually Preventive MaintenanceCleaning the Nylatrons Monthly Maintenanc PreventiveCode ProgrammingAfter the proportional control, press and release Review Usage Special Program ModeReset Usage ProgrammingSpeaker Frequency, Codes, Initialize System Factory Presets F/C, Gas/Electric, Speaker VolumeAppliance Test Tech I/O ModeMode Special ProgramHeat Control Problem Cause Correction Troubleshooting Trouble Shooting GuideDisplay Cause Panel Board Correction Error Codes303 O S S a R Y Model OFG Shortening level also referred to as fill lines Gas fryers only See ignition modules Henny Penny Corp., Eaton, Ohio 45320, Revised