Anritsu ML2430A operation manual System Specifications Appendix a, Vswr

SYSTEM SPECIFICATIONS APPENDIX A

Instrument Ac-
curacy:	< 0.5 %
Zero Set and	< 0.5 % MA2420A; < 0.5 % MA2470A Series and
Drift:	MA2440A Series. Percent of full scale in most sensitive
	range, measured over one hour with maximum averag-
	ing after one hour warm up at constant temperature.
Noise:	< 0.5 % of full scale in most sensitive range, measured
	over a one minute interval with maximum averaging,
	two standard deviations at constant temperature after
	one hour warm up, typical. MA2470A Series, 20 pW
	typical.

1.00 mW Power Reference

Frequency:	50 MHz nominal
Output Level:	1.00 mW, ± 1.2%/year, ± 0.9% RSS,
	traceable to National Standards
VSWR:	< 1.04
Connector:	Type N female
SENSOR / CHANNEL CONTROL
Operating	Readout: dual channel. RF power or voltage.
modes:	Power vs. Time: single channel graphic of readout data
	over adjustable time interval. RF power or voltage.
	Profile: single channel RF peak power graphic display
	for analysis of repetitive pulse or transient waveforms.
	Source Sweep: Single channel graphic display syn-
	chronized to an RF source.
Range Hold:	Current range or selectable 1 through 5. (6 with
	Universal Power Sensor).
Averaging	Auto-averaging: Moving average increases averaging
	at low power ranges.
	Averaging Types: Auto, Manual (Moving, Repeat)
	Manual Average Range: 1, 2, 4, ..., 512
	Low-Level Averaging: Low, Medium, and High settings
	apply post-average low pass filter to improve visibility
	at high display resolution settings.
Limit Lines:	Fixed value high and low limits with audible, rear panel
	TTL output, and/or visible Pass/Fail alarm indication.
	Failure indication can be set to latch until cleared so
	that a transient failure can be easily noticed.

A-2 ML2430A OM