HP 438A EMULATION COMMANDS

GPIB OPERATION

CC:sensor A range cc: sensor B range

DD:sensor A filter dd: sensor B filter

E:measurement units

F:active entry channel

G:OSC status

H:REL mode status

I:trigger mode

J:group trigger mode

K:limits checking status

L:sensor A limits status

M:sensor B limits status others not used

ST

Store setup

Syntax: ST<val>EN

val: 1 to 10

Remarks: Stores the present configuration to the selected register.

Example: To store the current instrument configuration in register 2:

ST2EN

Related

Commands: RC

TR0

Trigger hold mode

Syntax: TR0

Remarks: Sets both channels to trigger hold mode. It does not trigger until it receives a TR1 or TR2 or GET (group executive trigger), *TRG or TR3 command. If it receives a TR3 command it reverts back to the trigger mode it was in be- fore the TR0 command was sent. If the REM line is low, this command has no effect.

Related TR1, TR2, TR3, *TRG, Group Execute Trigger (GET), GT0, GT1, GT2

Commands:

TR1

Trigger immediate

Syntax: TR1

6-126

ML2430A OM

 

 

Page 213
Image 213
Anritsu operation manual 126 ML2430A OM