Anritsu ML2430A operation manual HP 436A Emulation Commands, Remarks

HP 436A EMULATION COMMANDS GPIB OPERATION

	dB (rel)
	Remarks:	Set to dB units in relative mode using the present relative reference value.
C	dB (ref)
	Remarks:	Set to dB units in relative mode using the present relative reference value,
		and enable the application of the calfactor.
D	dBm
	Remarks:	Set units to dBm.
EMUL	Select emulation mode
	Syntax:	EMUL <mode>
	mode: ML24XX (Anritsu ML2430A Series native mode)
		HP436A (Hewlett-Packard)
		HP437B (Hewlett-Packard)
		HP438A (Hewlett-Packard)
		ML4803 (Anritsu ML4803A Series)
	Remarks:	Sets the GPIB emulation to emulate other types of power meters. This
		command is available in any emulation mode, and resets the whole GPIB
		interface when the emulation mode is changed.
		When selecting GPIB emulation modes, the instrument configures itself to
		the preset conditions of the instrument to be emulated. For example,
		when selecting HP 438A emulation, the front panel menus pass through
		the presets for the HP 437B (which presets sensor A to dBm) then selects
		HP 438A emulation (which presets sensor A to Watts).
		NOTE
		This command requires a white space between the com-
		mand header (EMUL) and the parameter <mode>. This is
		an ML2430A-specific command that does not conform to
		the HP Emulation command format defined at the begin-
		ning of this section.
H	Hold mode
	Remarks:	Sets both channels to trigger hold mode. The power meter does not trigger
		until it receives an I or T command. If it receives an R or V command, it re-
		verts back to the trigger mode it was in before the H command was sent.

6-96 ML2430A OM