Anritsu ML2430A operation manual Mrf, Odt

GPIB OPERATION ML4803A EMULATION COMMANDS

Set the offset value at the specified memory location in dBm.

Syntax: MOF<mem><;><value>

mem: Memory location 1 to 30.

value: Offset value in dBm.

Remarks: Set the offset value at memory store address <mem> to <value> dBm

MRF	Set the reference value at the specified memory location in
	dBm.
	Syntax:	MRF<mem><;><value>
	mem:	Memory location 1 to 30.
	value:	Reference value in dBm.
	Remarks:	Set the reference value at memory store address <mem> to <value> dBm.
ODT	Output the current calibration factor, offset value, and refer-
	ence level.
	Remarks:	These are output as three separate messages in the output buffer, as
		shown below:
		CAL factor: 18 ASCII characters + <CR><LF>
		OFFSET value: 18 ASCII characters + <CR><LF>
		REFERENCE level: 19 ASCII characters + <CR><LF>
		1		5	10	15
			C A L			.	d B	<CR><LF>
			O F F S E T			.	d B	<CR><LF>
			R E F E R E N C E			.	d B m <CR><LF>

5 CHARACTER DATA

Figure 6-3.ODT Data Output Format

NOTE

When the ODT, OMR, and OPW data output commands are received simultaneously, only the command which is received last is valid.

ML2430A OM 6-89