Anritsu ML2430A operation manual 4TRIGGER Menu, Trigger

TRIGGER MENU APPENDIX C

C-4TRIGGER MENU	The Trigger menus are always available in PROFILE operation mode, as selected
	from the System menu. In READOUT and POWER vs. TIME modes, the trigger
	setup menus are available if a sensor used on a display channel has its
	SENSORSetupMODE set to CUSTOM. In READOUT mode, the trigger setup
	menus are available if the mode is set to Int A, Int B (ML2438A only), EXTTTL,
	Manual or Continuous.
Trigger		} only available if a sensor used on a display
		} channel is in “custom measurement mode” and
		} system setup mode = READOUT or Power
		} vs. TIME; or if system setup mode =
		} PROFILE; or link readout/profile trigger = ON
		} channels only available if ON
Setup
[TRGMODE]	CHANNEL	} only available if system setup mode = Readout or
		} Power vs. Time, both with “link triggers” OFF
	1 2 1&2
[TRGSRC, GTSRC]	SOURCE		} int B not available in ML2437A
	Continuous int A int B EXT TTL manual
[TRGDLY, GTDLY]	Sample DELAY
	0 to 1 second
[TRGGW, GTGW]	Sample gate WIDTH
	100ns to 7 seconds
[TRGARM, GTARM]	Trigger ARMING		} if SOURCE = continuous or internal A
			} or internal B on ML2438A, or manual
	Blanking ON blanking OFF
[TRGTYP, GTTYP]	Trigger TYPE and level menu		} if source = internal A or internal B on
ML2438A
	Trigger TYPE
		Rise fall
[TRGLVL, GTLVL]	Trigger LEVEL
		-30 dB to +20 dB
[TRGXTTL, GTXTTL]	Trigger EDGE		} if source = EXT TTL
	Rise fall
Trig 1			} if trig chan 1 = manual
Trig 2			} if trig chan 2 = manual
Trig 1&2			} if trig chan 1&2 = manual

C-8 ML2430A OM