Anritsu ML2430A operation manual Related Commands *RCL, Syntax *SRE?, Syntax *STB?, Syntax *TRG

ML24XXA NATIVE COMMANDS GPIB OPERATION

Related

Commands: *RCL

*SRE Setup service request enable register GPIB 488.2

Syntax: *SRE <val>

val: 8-bit mask

Remarks: Sets the Service request enable register bits.

*SRE? Return Service Request Enable register GPIB 488.2

Syntax: *SRE?

Remarks: Returns the Service Request Enable register.

*STB? Return Status Byte register GPIB 488.2

Syntax: *STB?

Remarks: Returns the status byte value with bit 6 replaced with the MSS value. MSS is the GPIB Master Summary Status, and indicates that the device has at least one reason for requesting service. Although the MSS message is sent in bit position 6 of the device’s response to the *STB? query, it is not sent in response to a serial poll and should not be considered part of the IEEE 488.1/2 status byte. MSS = the Status Byte (STB) OR`ed with the Service Request Enable register (SRE). Unlike the *ESR? Command, this command does not clear the register afterwards.

*TRG Perform the GPIB 'Group Execute Trigger' command GPIB 488.2

Syntax: *TRG

Remarks: Performs a 'GET' command. The GT0, GT1 and GT2 commands set the response to the GET or *TRG commands. When the ML2430 Series is triggered using this command or the 488.1 hardware trigger, a trigger and output for each display channel that is not OFF gives a response in the output queue. If both display channels are displayed, there will be two messages in the output queue to be read out.

Related

Commands: GT0, GT1, GT2

6-16 ML2430A OM