Anritsu ML2430A operation manual NORMAL, Min&Max, Min, or Max

SYSTEM MENU OPERATION

Anritsu 68/69000 Synthesized Sweep Generator

HORIZ OUT

SEQ SYNC OUT

10 MHz	10 MHz	NOTE: USE SLOW BLO FUSES ONLY
REF IN	REF OUT

		!	CAUTION	220V		110
		> 18 kg		2.5A		LINE
				110V
	HORIZ			5A	!	SELECT
AUX I/O	OUT		HEAVY WEIGHT			CAUTION
						DO NOT OPERATE
						WITH POWER CORD
	SEQ	EXT				UNGROUNDED
			INPUT
	OUT	IN
	SYNC	ALC
			90 - 132VAC
			180 - 264VAC
			48 - 440Hz
		DWELL
		IN		IEEE-488 GPIB
	V/GHz	SERIAL
	OUT	I/O

ML2430A Series Power Meter

DIGITAL INPUT 1

ANALOG INPUT 2

BNC Cables

Figure 4-5.Source Sweep Mode Interconnection Example

If the source used does not provide a blanking output, the blanking signal may be disabled as follows: select SystemRear PanelBNC. Select PORT until INPUT 1 (digital) is selected, then select TTL Level to alter the active state of the blanking signal expected. Setting the TTL Level to LOW will allow the Source sweep to progress without a Blanking signal. This is useful for third party sources or simple VTO systems. If a Source Sweep is later selected which does provide a blanking signal, remember to restore the polarity of this signal to HIGH or an incorrect dis- play will result. Operating a source sweep which has BANDSWITCH blanking de- lays in it without an appropriate blanking signal may lead to glitches in the resulting measurement at the bandswitch points (simple VTO systems do not usually have bandswitch points).

Source sweep operation mode includes the following display controls:

NOTE

If either Min&Max, Min, or Max is selected, the display will keep the “old” data and may ap- pear stationary. The DATA HOLD mode in use is displayed on the left of the screen, below the middle value of the y axis.

CHANNEL	Select Channel 1 or Channel 2. The channel selected will be dis-
[GRMD]	played on the left of the screen, above the middle value of the y
	axis.
DATA HOLD	This selects how the graph is displayed on the screen. Select from
[GRPIX]	NORMAL, Min&Max, Min, or Max.
	With Min & Max selected, the minimum and maximum points for
	each sample are shown. If Connect Points is ON (SYSTEMGraph-
	icsCONNECT), a vertical bar is drawn between these points. Min
	displays only the minimum for this sample. Max displays only the
	maximum for this sample.
MODE	Source sweep mode: FREQUENCY or POWER.
[SRCMOD]

START Sweep start frequency (MHz or GHz) or power (dBm)

[SRCSTFRQ

SRCSTPWR]

4-24 ML2430A OM