SYSTEM ERROR MESSAGES | APPENDIX A |
Error Message | Meaning |
|
|
SENSOR A not fitted | Sensor A is required for the current |
| measurement, but is not fitted. |
READING SENSOR A data | as per message |
|
|
SENSOR B not fitted | Sensor B is required for the current |
| measurement, but is not fitted. |
READING SENSOR B data | as per message |
|
|
Printer buffer full | Try selecting print, when current job finished. |
Printer - Check paper | Printer reporting “0ut of paper.” |
Printer Error | Printer communication error. |
|
|
Chan 1 - NO trigger | Waiting for trigger on specified channel for |
Chan 2 - NO trigger | more than 6 seconds |
| |
|
|
Increase PERIOD to > 6 ms | WARNING: In profile mode, when using |
| manual or continuous trigger, the data col- |
| lection period must be > 6 ms. |
|
|
Graph Display HELD | warning message |
|
|
Updating SENSOR data | Programming SENSOR EEPROM |
|
|
Graph Channel Off | In any graph mode, the selected display |
| channel is off. |
|
|
Ext Volts ZERO in progress | as per message |
|
|
Put sensor number limit | Attempt to read/write sensor B setup on |
| ML2437A |
|
|
Sensor A cal factor error | Cal factor out of range - sensor A |
|
|
Sensor B cal factor error | Cal factor out of range - sensor B |
|
|
PUT current mode limit | Present configuration will not allow re- |
| quested change. |
|
|
Internal error (P6) | Entered numeric value out of range |
|
|
Internal error (P10) | Requested action NOT allowed |
|
|
Internal error (P20) | Cal factor edit - duplicate frequency entered |
|
|
Internal error (P21) | Cannot delete last cal factor data pair in se- |
| lected table, or cannot add cal factor data |
| pair in selected table |
|
|
Internal error (P22) | Cannot delete 50 MHz cal factor in selected |
| table |
|
|
Internal error (P23) | Non valid cal factor table |
|
|
|
|
ML2430A OM | |
|
|
