Anritsu ML2430A operation manual 7HP-IB Support, HP 437B Commands

HP-IB SUPPORT APPENDIX B

B-7HP-IB SUPPORT		The following tables list HP-IB commands for the HP 437B and HP 438A
		power meters, and which commands are supported in the Anritsu
		ML2430A Series power meter. Restrictions, if any, are also listed. Com-
		mands that are not supported will be ignored.
HP 437B Commands
	Mnemonic	Action	Supported?	Restrictions
	CL	CAL 0 dBm	Yes	None
	*CLS	Clear Status	Yes	None
	CS	Clear status	Yes	None
	CT0-CT9	Sensor data tables	Yes	None
	DA	Set all screen pixels	Yes	None
	DC0	Duty cycle OFF	Yes	None
	DC1	Duty cycle ON	Yes	None
	DD	Disable display	Yes	DISP OFF restrictions: Screen and
				min/max not updated, Relative not active
	DE	Display enable	Yes	DISP ON. None.
	DF	Disable Display	Yes	see DD
	DN	Down arrow	No	Not supported
	DU	User message	No	Not supported
	DY	Duty cycle	Yes	None
	EN	Enter msg terminator	Yes	None
	ERR?	Error query	No	Not supported
	*ESR?	Read event reg	Yes	None
	*ESE	Set event enable reg	Yes	None
	*ESE?	Read event enable reg	Yes	None
	ET0-ET9	Edit cal factor table	Yes	None
	EX	Exit	Yes	None
	FA	Auto average	Yes	None
	FH	Average hold	Yes	None
	FM	Manual average	Yes	None
	FR	Set frequency	Yes	Switch to frequency cal factor source.
	GT0	Ignore GET	Yes	None
	GT1	TR1 on GET	Yes	None
	GT2	TR2 on GET	Yes	None
	GZ	Terminator	Yes	None
	HZ	Terminator	Yes	None
	ID	Return ID string	Yes	None
	IDN?	Return ID string	Yes	None
	KB	Set cal factor	Yes	None
	KZ	Terminator	Yes	None
	LG	Units to dBm	Yes	None
	LH	Set high limit	Yes	On channel not sensor.
	LL	Set low limit	Yes	On channel not sensor
	LM0	Limit check off	Yes	Both high and low off as HP 437B

B-16 ML2430A OM