Anritsu ML2430A operation manual Cca, Cdj, Cof, Cos, Crf, Cst, Dbm, Dbr

ML4803A EMULATION COMMANDS GPIB OPERATION

CCA	Clear the calfactor value to zero.
CDJ	Perform a CAL 0 dBm.
	Remarks:	During the cal 0 dBm sequence, the CAL execution bit in the status byte is
		set. When the CAL operation is completed, the CAL execution bit is
		cleared.
COF	Clear the offset value to zero.
COS	Turn ON the 50 MHz, 0 dBm RF calibrator output.
CRF	Clear the reference value to zero.
CST	Turn OFF the 50 MHz, 0 dBm RF calibrator output.
DBM	Sets the display channel units to dBm.
DBR	Sets the display channel units to dB’s and takes the relative
	value.
	Remarks:	The relative value is stored as the reference data. The reference value can
		be independently changed with the GPIB command REF.
EMUL	GPIB emulation mode
	Syntax:	EMUL <mode>
	mode: ML24XX (Anritsu ML2430A Series native mode)
		HP436A (Hewlett-Packard)
		HP437B (Hewlett-Packard)
		HP438A (Hewlett-Packard)
		ML4803 (Anritsu ML4803A Series)
	Remarks:	Set the GPIB emulation to emulate other types of power meters. This com-
		mand is available in any emulation mode, and resets the whole GPIB inter-
		face when the emulation mode is changed.

6-86 ML2430A OM