Anritsu ML2430A operation manual Print, Battery

OPERATION SYSTEM MENU

Print	This selection prints the screen and various operational settings through the rear
[PRINT]	panel printer port.
	ANRITSU Power Meter ML2437A s/n: 97180010
	Firmware: 2.02
	Sensor A: NOT FITTED
	Sensor Measurement Setup		A:
	Measurement mode		Default
	Cal factor		Frequency (50.00MHz)
	Averaging mode & number		Auto
	Low level averaging		Low
	Offset type & value		Off
	Settle % per reading		0.10%
	Range hold		Off
	Sensor zeroed		No
	Measurement Channel Setup		1: (A)	2: OFF
	Trigger source		Continuous
	Trigger sample delay		1.00ms
	Trigger gate width		20.00ms
	Trigger arm		Blanking OFF
	High limit		Off
	Low limit		Off
	Limits test		Off
	Readout		1:
	Measured value		------
	Figure 4-7.Sample ML2430A Series Printout
Battery	Controls battery setup when the optional battery pack is installed.
	AUTO	Enables or disables the automatic power off feature. Automatic
	[BAUTS]	power off can be used to conserve battery power when operating
		from the internal battery.
	TIME	When operating from the internal battery, Time sets the number of
	[BAUTT]	minutes that the instrument will run before powering off in absence
		of any key activity. Enter a value of 10 to 240 minutes.
	STATUS	Displays the installed battery type, remaining capacity (%), esti-
		mated operating time remaining (minutes), and the battery’s full
		charge capacity (mAh).

ML2430A OM 4-29