Anritsu ML2430A operation manual HP 437B Emulation Commands, 14HP 437B Emulation

HP 437B EMULATION COMMANDS GPIB OPERATION

6-14HP 437B EMULATION		This section provides an alphabetical listing of the commands (mnemon-
COMMANDS		ics) used to program the Model ML2430A Series Power Meter when in HP
		437B Emulation mode. The emulation mode can be set through the front
		panel SYSTEMRear PanelGPIBMODE menu (see Chapter 4, Opera-
		tion) or through the GPIB command EMUL (page 6-105).
		HP Emulation commands must not have a space between the command
		header and the parameter, or commas between the parameters.
		The format for HP Emulation commands is:
		<command header><parameter 1><parameter n>...
		The end of the command text must be terminated with a line feed charac-
		ter (0Ah, decimal 10) or a GPIB End of Transmission State (EOI), or both.
*CLS	Clear GPIB status bytes
	Syntax:	*CLS
	Remarks: This command performs a status structure clear command. The event
		status register and the status register are cleared except for the MAV bit.
*ESE	Set the Event Status register enable mask
	Syntax:	*ESE<val>
	val:	8-bit mask
	Remarks: Event registers for the HP 437B (see Figure 6-8):
		Bit 7: Power ON
		Bit 6: N/A
		Bit 5: Command error
		Bit 4: Execution error

Bit 3: Device Dependent error

Bit 2: N/A

Bit 1: N/A

Bit 0: N/A

See the HP 437B manual for details about the HP status registers.

6-100 ML2430A OM