Anritsu ML2430A operation manual Syntax SM, Syntax SNval

HP 437B EMULATION COMMANDS GPIB OPERATION

Remarks: Selects the cal factor table to be used.

SM status message

Syntax: SM

Remarks: Returns the status message in the format: AAaaBBCCccDDddEFGHIJKLMNOP<cr><lf> where:

AA:measurement error code aa: entry error code

BB:operating mode

CC:sensor A range

cc: 0

DD:sensor A filter dd: 0

E:linear/log units

F:A

G:pwr ref status

H:REL mode status

I:trigger mode

J:group trigger mode

K:limits checking status

L:sensor A limits status

M:0

N:offset status

O:duty cycle status

P:measurement units

SN Cal table identity update

Syntax: SN<val>

val: up to seven characters

Remarks: Since the ML2430A stores the cal factor table information in the sensor, this data must be saved to the sensor by using the ‘EX’ command or an additional command ‘SV’, or the data could be lost. The saving of the cal factor table data to the sensor can be done at the end of all updates to a particular table.

ST Store setup

Syntax: ST<val>EN

val: 1 to 10

6-114 ML2430A OM