Anritsu ML2430A operation manual String can only be defined over the Gpib

SYSTEM MENU OPERATION

Contrast Reduces the display contrast. Adjust to suit ambient conditions.

DOWN [DCONTD DCONT]

Contrast Increases the display contrast. Adjust to suit ambient conditions.

UP [DCONTU DCONT]

TIMED [DBLTIM]

PEAKMETER [DPEAK]

Sets the time limit when the backlight will turn off if the BACKLIGHT setting is set to TIMED. Enter a value from 0.0 to 100.0 minutes.

Turns on the peakmeter display for Sensor A, Sensor B, or both Sensors A and B. The peakmeter display will eclipse any trigger icons. The peak meter display range covers 12 dB. When above the displayed maximum or below the displayed minimum, the range is switched by 10 dB in the appropriate direction.

Note that in the event that the channel is displaying an alternative measurement (for example, external volts from the rear panel BNC) the peak meter will continue to represent the Sensor A and/or B data. This is useful for monitoring an external voltage on the meter, while peaking up a response being monitored by a sensor, such as RF output.

FREQ [FROFF]

Turns FREQuency offset display ON or OFF. When ON, a continu- ous indication of the frequency (used for Cal Factor) is displayed in small text at the top of the display along with any sensor offset (if applied).

TEXT	GPIB user TEXT display ON or OFF. When ON, a user-defined text
[TEXT	string can be displayed at the top of the display area. The text
TEXTS]	string can only be defined over the GPIB.

Sound Controls system sounds.

KEY	Turns the audible key click on or off.
[KEYCK]
EDIT	Turns the audible edit error tone on or off.
[ENTERR]
LIMIT 1	Limit Fail beep on channel 1 on or off.
[FBEEP]
LIMIT 2	Limit Fail beep on channel 2 on or off.
[FBEEP]
CURSOR	CURSOR out of screen beep. If a cursor is moved into an illegal
	space, such as the edge of the screen or the end of valid data, a
	warning beep is sounded.

4-28 ML2430A OM