Anritsu ML2430A operation manual Gpib PC Card Setup, 5GPIB PC Card, Gpib Device Template

GPIB OPERATION GPIB PC CARD SETUP

6-5GPIB PC CARD	The following GPIB driver configuration set up is recommended for reliable GPIB
SETUP	communication with the ML2430A Series power meter. The set up is expressed
	in the terms used by the National Instruments GPIB ISA and PCI cards and driv-
	ers for WIN95 and DOS.
GPIB Device Template	The ML2430A Series default primary address is 13. Separate device templates
	for the primary address of each device can usually be set up separately. The set-
	tings for the device template for the ML2430A Series are:
	Terminate read on EOS	NO
	Set EOI with EOS on write	YES
	Type of compare on EOS	8 bit
	EOS byte	0x0A (10 decimal)
	Send EOI at end of write	YES
	Readdressing	YES
	Secondary address	NONE

GPIB Card Settings The recommended GPIB card settings for use with the ML2430A Series are:

Terminate read on EOS	NO
Set EOI with EOS on writes	YES
Type of compare on EOS	8 bit
EOS byte	0x0A (10 decimal)
Send EOI at end of write	YES
System controller	YES
Assert REN when SC	YES
Enable Auto Serial polling	NO
NI card. Cable length for HS488	OFF

ML2430A OM 6-5