Anritsu ML2430A operation manual Duty cycle, Rng Hold, Rgh

SENSOR MENU OPERATION

	TABLE	Select the offset table number (1-5) when Offset TYPE is set to Ta-
	[OFFTBL	ble. When a table is selected, additional soft keys become
	OFFTBR	available:
	OFFTBU
	OFFVAL]
		EDIT
		This will bring up all of the selected offset table’s entries, with their
		associated frequencies and offsets. Select an entry and enter the
		frequency and offset using the keypad.
		CLEAR [OFFCLR]
		When an offset table is selected, CLEAR will set all of the table’s
		elements to zero.
Duty cycle	Applies a duty cycle to the selected sensor. An offset will be applied based on the
	entered value.
	SENSOR	Model ML2438A (dual channel) only. Used to select the sensor to
		be configured. Toggles between sensor A and sensor B for all sub-
		menu functions.
	STATE	ON or OFF
	[DUTYS]
	DUTY	Delete, Enter, or Cancel. An offset will be applied based on the en-
	[DUTYS]	tered value. For example, specifying a duty cycle of 50% will alter
		the displayed readings by approximately +3.01 dB.

Rng Hold

[RGH]

NOTE

Rng Hold is not available when SystemSetupmode is set to Source Sweep. In this mode, AUTO ranging is

This function will toggle the sensor between holding the present operating range and Auto Ranging. Auto Ranging automatically selects the best range to take the measurement.

If either sensor is auto ranging, this key will force both sensors to hold their pres- ent operating ranges. If either sensor is held within an operation range, this key will force both sensors to Auto Range.

4-12 ML2430A OM