Anritsu ML2430A Val To 1.0 seconds, Time the system waits after a trigger event has happened

GPIB OPERATION ML24XXA NATIVE COMMANDS

c:1, 2 or 1&2

val:	0.0 to 1.0 seconds
Remarks:	The time the system waits after a trigger event has happened
	before taking measurements when in READOUT or POWER vs. TIME
	mode.
	Select channel 1, 2 or 1&2. Selecting 1&2 allows both channels to trigger
	together on the same conditions without having to set up two sets of trig-
	ger data.
Query:	TRGDLY? <c>
Returned
String:	TRGDLY <c>,<val>
	The TRG type commands return the trigger state of the selected channel if
	the channel is ON. This depends on the settings of the “link triggers” flag
	and the current mode of the sensor on the selected channel. If the channel
	is OFF, the stored trigger state of the channel is returned.

TRGGW Set trigger gate width TRIGGER

Syntax: TRGGW <c>,<val>[units]

c:1, 2 or 1&2

val: 100 ns to 7.0 seconds

Remarks: The length of time the system uses to collect data when in READOUT or POWER vs. TIME mode. The default value is 20 ms.

Select channel 1, 2 or 1&2. Selecting 1&2 allows both channels to trigger together on the same conditions without having to set up two sets of trig- ger data.

Query: TRGGW? <c>

Returned

String: TRGGW <c>,<val>

The TRG type commands return the trigger state of the selected channel if the channel is ON. This depends on the settings of the “link triggers” flag and the current mode of the sensor on the selected channel. If the channel is OFF, the stored trigger state of the channel is returned.

TRGLVL Set trigger level TRIGGER

Syntax: TRGLVL <c>,<val>

c:1, 2 or 1&2

val: –30 to +20 dBm

ML2430A OM 6-79