Anritsu ML2430A operation manual Rack Mounting

INSTALLATION RACK MOUNTING

Locate the support bracket on the four PM case pillars. Secure with 4 screws 905-68 and 4 washers 900-345. (See max. torque settings page 2-4.)

5.Locate the front rack mounting bracket C37276 at the front of the PM on the other side to the large support bracket with two screws 905-68 and two washers 900-345. (See max. torque settings page 2-4).

6.Locate the rear bracket C41449 at the back of the PM on the other side to the large support bracket with two screws 905-68 and two washers 900-345. See maximum torque settings above.Locate the rear bracket C41449 at the back of the PM on the other side to the large support bracket with two screws 905-68 and two washers 900-345. (See max. torque settings page 2-4).

7.Fit the front plate 49362 with 6 screws 905-72. (See max. torque settings page 2-4).

8.Position the base panel 49361 as shown in the drawing, and secure with 6 snap rivets 788-575.

9.Fit the four speed nut 790-319 to the rack in the correct place to allow mounting of the PM in the rack.

10.Slide the PM into the rack and secure with 4 decorative screws 900-821.

NOTE:

FIT COMPLETED ASSEMBLY TO RACK USING DECORATIVE SCREW 900-821 X4 AND SPEED NUT 790-319

X4 IN 4 CORNER POSITIONS AS SHOWN

788-575

X6

SNAP RIVET

PRESS DOWN CENTER PIN USING A FLAT EDGE

	49361
041473	BASE PANEL
SUPPORT
BRACKET	905-68
	X8

905-72	900-345
X6
	X8
SCREW

900-795

X4

	C41449
	RACKMOUNT
	BRACKET
49362	REAR SUPPORT
FRONT PLATE

783-1055

HANDLE X2

C37276 RACKMOUNT SIDE BRACKET

ML2430A OM 2-5