Anritsu ML2430A operation manual Front Panel, Connectors, Calibrator 0.0 dBm Reference

Chapter 3 Connections

3-1

3-2

INTRODUCTION	This chapter describes physical connections to the power meter on both
	the front and rear panels.
FRONT PANEL	The front panel connectors are illustrated in Figure 3-1.Detailed descrip-
CONNECTORS	tions of each connector follow.

Calibrator

Connector

Sensor A

Connector

Sensor B

Connector

(ML2438A only)

Figure 3-1.Model ML2430A Series Power Meter Front Panel Connectors

Calibrator 0.0 dBm Reference

This connector is a precision female N-Type, 50 Ohm connector that provides a precision, traceable 0.0 dBm, 50 MHz reference signal for absolute calibration of the sensors. The calibration signal can be turned on or off through the Cal/Zero menus (see Chapter 4, Front Panel Operation). Use only compatible 50 Ohm N- Type connectors.

ML2430A OM 3-1