Anritsu ML2430A operation manual Related Commands, Query, Returned String, Mode

GPIB OPERATION ML24XXA NATIVE COMMANDS

*TST?	Self Test				GPIB 488.2
	Syntax:	*TST?
	Remarks:	Performs a self test and returns 'PASSED' or 'FAILED.'
		NOTE: This command will restart the sweep in Power vs. Time mode.
	Related
	Commands:	STERR
ADDR	Change GPIB address
				GPIB SETUP
	Syntax:	ADDR <val>
	val:	1 to 30
	Remarks:	Once the address has been changed, the ML2430A Series will no longer
		respond to the old address. The power meter default address is 13.
	Query:	ADDR?
	Returned
	String:	ADDR <val>
AVG	Sets up averaging for a sensor.
						SENSOR
	Syntax:	AVG <s>, [<mode>],[<val>]
	s:	A or B
	mode:	OFF
		MOV	Moving
		RPT	Repeat
		AUTO	Automatic
	val:	ASCII string representing an integer, 1 to 512.
	Remarks:	MOVING average gives an update to the meter every sample/gate (nor-
		mally 20 ms).

REPEAT averaging only returns a reading when the number of readings specified by <val> have been taken (1-512).

AUTOMATIC averaging uses a MOVING type of average. The display up- dates at approximately 100 ms intervals, however the data is available at the full rate. The display is slowed down to prevent jitter and allow the user to follow the update. Since AUTOMATIC averaging automatically chooses an average number with the averaging mode set internally to MOVING, the USER averaging number is not used. However, if a value is entered in the

ML2430A OM 6-17