Anritsu ML2430A operation manual Mca, Mem, Mcc, Mco, Mcq

GPIB OPERATION ML4803A EMULATION COMMANDS

		When selecting GPIB emulation modes, the instrument configures itself to
		the preset conditions of the instrument to be emulated. For example, when
		selecting HP 438A emulation, the front panel menus pass through the pre-
		sets for the HP 437B (which presets sensor A to dBm) then selects HP
		438A emulation (which presets sensor A to Watts).
		NOTE
		This command must be entered using the 488.2 format;
		that is, EMUL<ws><mode> (<ws> = white space).
MCA	Set the cal factor value at the specified memory location in
	dBm.
	Syntax:	MCA<mem><;><value>
	mem:	Memory location 1 to 30.
	value:	Cal factor value in dBm.
	Remarks:	Set the cal factor value at memory store address <mem> to <value> dBm.
MCC	Clears the cal factor value at the specified memory loca-
	tion.
	Syntax:	MCC<mem>
	mem:	Memory location 1 to 30.
	Remarks:	Clears the cal factor value at memory store <mem> to 0.0 dBm.
MCO	Clears the offset value at the specified memory location.
	Syntax:	MCO<mem>
	mem:	Memory location 1 to 30.
	Remarks:	Clears the offset value at memory store <mem> to 0.0 dBm.
MCQ	Clears the frequency value at the specified memory loca-
	tion.
	Syntax:	MCQ<mem>
	mem:	Memory location 1 to 30.
	Remarks:	Clears the frequency value at memory store <mem> to 0.1MHz.

ML2430A OM 6-87