SYSTEM MENU

OPERATION

POWER [MODPWR] – If this is set, and the power cycles on the meter, then the number specified in the “phone number” field will be dialed. When a connection is established, an SRQ will be sent to the host PC. Remote communications can then continue as normal.

BNC Configures the input and output rear panel BNC connectors.

[OBMD, OBCH,

OBVST, OBVSP, OBDST, OBDSP, OBCH, OBPL,

OBACM, OBCH, OBZL, IBBLP]

PORT

Output 1 or 2: Select the output port to configure (see MODE below).

Input 1: Select what type of Blanking input you are providing (see

TTL LEVEL below) on Input 1.

Input 2: Selects input 2 for V/GHz or External volts input. You can- not configure the V/GHz or External volts input port here. To config- ure V/GHz set SensorCalFactorSource to V/GHz. To use the External Volts Input set ChannelSetupInput to EXT V.

MODE (output ports only)

OFF (output set to ground) port 1 or 2

Analog OUT (analog scaled output) port 1 or 2 provides an output voltage proportional to the measurement.

RF Blanking (output 2 only) provides a logic level output during the ZERO process. This can be used to switch off RF from external sources.

PASS/FAIL port 1 or 2 logic level output

Signal channel A or B (port 1 or port 2) provides a real time output from the signal channel. Being real time, it shows modulation, etc., and is taken after the signal has been through range amplifiers. It is not directly proportional to the measurement.

Leveling A or B (range 1 or 2) (port 1 or 2). This is similar to the sig- nal channel A or B outputs, except it connects to range 1 or 2 only of the signal channel. See below for more information on leveling.

4-32

ML2430A OM

 

 

Page 60
Image 60
Anritsu ML2430A operation manual Port