Kenmore 106.511800 manual On soe n,¢odes, Complete the Installation

Style 3

1. Unplug refrigerator or disconnect power.

2.Remove and discard the black nylon plug from the gray water tube on the rear of the refrigerator.

3.If the gray water tube supplied with the refrigerator is not long enough, a 1/4" x 1/4" (6.35 mm x 6.35 mm) coupling is needed in order to connect the water tubing to an existing household water line. Thread the provided nut onto the coupling on the end of the copper tubing.

NOTE: Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten.

A	B	C	D	E	F		G
A. Refrigerator	water	tubing		E. Ferrule		{purchased)
B. Nut {provided)				F. Nut	{purchased)
C, Bulb				G. Household			water line

D. Coupling {purchased)

4.Turn shutoff valve ON.

5.Check for leaks. Tighten any nuts or connections (including connections at the valve) that leak.

Complete the Installation

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

I.Plug into a grounded 3 prong outlet.

2.Flush the water system. See "Prepare the Water System" or "Water and Ice Dispensers."

NOTE: Allow 24 hours to produce the first batch of ice. Allow

3 days to completely fill ice container.

sta Cea ' Fow F

(on so_>e n,¢odes}

On some models, your refrigerator's accessory packet includes an air filter, which must be installed prior to use. On some models the air filter is already installed at the factory.

The air filter reduces the buildup of odors. This helps to maintain

a cleaner environment inside the refrigerator.

Installing the Air Filter (on some models)

The filter should be installed behind the vented door, which is located (depending on your model) along either the rear or left

interior wall near the top of the refrigerator comoartment.

1.Remove the air filter from its packaging.

2.Lift open the vented door.

3.Snap the filter into place.

Installing the Filter Status Indicator (on some models)

The filter comes with a status indicator, which should be activated and installed at the same time the air filter is installed.

1.Place the indicator face-down on a firm, flat surface.

2.Apply pressure to the bubble on the back of the indicator, until the bubble pops to activate the indicator.

3.Lift open the vented air filter door. There are notches behind the door. Slide the indicator down into the notches, facing outward.

13