Dispensing Options
Your dispenser can dispense water and ice in two ways.
•The DISPENSE WATER button, located below the dispenser control panel's display screen, dispenses only water.
•The dispenser pad is the pad located along the rear wall of the dispenser cavity. When pressed, it dispenses either water
or ice, depending on the chosen setting.
To dispense both water and ice at the same time, select the desired type of ice and dispense it using the dispenser pad, then press the DISPENSE WATER button while still dispensing ice.
Calibrate Measured Fill
Household water pressure may affect the accuracy of the
Measured Fill feature. For optimum performance of your water dispenser, you must first calibrate Measured Fill.
IMPORTANT: Flush the water system before calibrating Measured Fill.
Place a sturdy measuring cup (1 cup size) on the dispenser tray, centered in front of the water dispenser pad.
NOTE: Depending on your model, a measuring cup may be provided.
2.Press and hold the SETTINGS and LOCI( buttons at the same time for 3 seconds. The words "Back" and "1 Cup" will appear on the display screen. Also, "CALIBRATION" will illuminate and remain lit while the Measured Fill feature is being calibrated.
NOTE: You may press the WATER/ICE button under the word "Back" at any time to exit calibration mode. The display screen's"CALIBRATION" text will turn off.
3.Using your hand (not the measuring cup), press and release the water dispenser pad in order to dispense water to the 1 cup fill line.
The Water Dispenser
IMPORTANT:
•Dispense at least 1 qt (1 L) of water every week to maintain a fresh supply.
•If the flow of water from the dispenser decreases, it could be caused by low water pressure.
•With the water filter removed, dispense 1 cup of water. If 1 cup of water is dispensed in 8 seconds or less, the
water pressure to the refrigerator meets the minimum requirement.
•If it takes longer than 8 seconds to dispense 1 cup of
water, the water pressure to the refrigerator is lower
than recommended. | See | "Water | Supply Requirements" |
or "Troubleshooting" | for | suggestions. | |
To Dispense Water (Standard):
NOTE: While dispensing water and for 3 seconds after dispensing has stopped, the digital display will show how much water has been dispensed. The default unit is ounces. To switch to cups or liters, press the SETTINGS button, then press
MEASURED FILL to toggle through the available units. Option 1:
1.Place a sturdy glass below the dispenser opening.
2.To dispense water, press the DISPENSE WATER button.
3.To stop dispensing, press the DISPENSE WATER button a second time.
Option 2:
1.Press the WATER/ICE button until "Water" is selected.
2.Press a sturdy glass against the dispenser pad.
3.Remove the glass to stop dispensing.
NOTE: If overfilling or spilling occurs, discard the water and press "Back" to restart the calibration process.
4.When 1 cup of water has been correctly dispensed into the measuring cup, press the MEASURED FILL button under the
word "Confirm" to confirm the calibration.
When Measured Fill calibration has been confirmed, the display will return to the home screen.
To Dispense Water (Measured Fill):
Measured Fill allows you to dispense a specified amount of water with the touch of a few buttons.
NOTE: The amount of water you select will be dispensed. Be sure that the container is empty and can hold the entire volume. If ice is in the container, you may need to adjust your selection.
IMPORTANT: Low water pressure may affect the accuracy of this feature.
1.Press MEASURED FILL to turn the feature on. When the feature is on, the Measured Fill screen appears on the display.
18