Weed Eater manual Adjusting the Handle Models W25CB, W25SB, W25CF, W25SF, Attaching Shield

Upper Shaft

Grooves

Lower Shaft

2.Push the two shafts together until the lower shaft is fully seated in the upper shaft.

3.Slide lower lockingsleeve assembly over upper locking sleeve assembly and tight-

en by turning clockwise.

Upper Locking Sleeve Assembly

Lower Locking

Sleeve Assembly

NOTE: If lower locking sleeve assembly will not tighten (gap is more than 1/4″), the upper and lower shafts are not fully seated.

Gap is more than 1/4″

ADJUSTING THE HANDLE (Models W25CB, W25SB, W25CF, W25SF)

CAUTION: When adjusting the assist handle, be sure it remains above the safety label and below the mark or arrow on the shaft.

1.Loosen wing nut on handle.

2.Rotate the handle on the shaft to an upright position; retighten wing nut.

ADJUSTING THE HANDLE (Models W25CBK, W25CFK, W25SBK, W25SFK)

CAUTION: When adjusting the assist han- dle, be sure it remains above the upper lock- ing sleeve and below themark or arrow onthe shaft.

1.Loosen wing nut on handle.

2.Rotate the handle on the shaft to an upright position; retighten wing nut.

ATTACHING SHIELD

CAUTION: The shield must be properly installed. The shield provides partial protection from the risk of thrown objects to the operator and others and is equipped with a line limiter blade which cuts excess line to the proper length. The line limiter blade (on underside of shield) is sharp and can cut you.

For proper orientation of shield, see KNOW YOUR TRIMMER illustration in OPERATION section.

1.Remove wing nut from shield.

2.Insert bracket into slot as shown.

3.Pivot shield untilbolt passes through holein bracket.

4.Securely tighten wing nut onto bolt. Shield

Bracket

Slot

Wing Nut

6