Line Keys, Programmable Keys, and Softkeys
41-001451-00 REV00 – 07.2011 112
Using the Paging Key
The following procedure describes the use of the Paging key on the IP Phone. The procedure assumes you have already
configured the Paging key using the Aastra Web UI.
12. In the "Type" field, select Paging.
13. (M675i) In the “Label” field, enter a label to apply to this key.
14. In the “Value” field, enter a multicast IP address and a port number for the Paging key. When you press this key,
the phone initiates an outgoing multicast RTP session to the specified address using the specified port. (For example,
239.0.1.15:10000).
Notes:
1. When you select Paging for the “Type” field, the “Line” field is disabled.
2. The “Value” field allows for one multicast address entry only.
15.To receive RTP steams for Group Paging, you must also configure the "Paging Listen Addresses" parameter at the
path, Basic Settings->Preferences->Group Paging RTP Settings. For more information about setting this parameter,
see “Group RTP Paging (receives RTP streams)” on page183.
16. Click Save Settings to save your changes
IP Phone UI
Notes:
1. Recipient of a Paging call can set a global “Do Not Disturb” (DND) to ignore any incoming pages.
2. For incoming Paging, the phone uses the Intercom configuration settings. The incoming Page is dependant on the
“Allow Barge-In” parameter setting and the “Idling/On Call” state.
1. On the IP Phone, press the softkey, programmable key, or expansion module key you configured for Paging (labeled
as “Group 1” in the following illustration).
The phone opens a multicast RTP session and an outgoing OR incoming phone screen displays as follows.
2. Press the Drop key to end the multicast RTP session and return to the idle screen.
Tues Jan1 10:00am
Services
Dir
Callers
Icom
Group 1
LAB
ACD
Paging
Drop
00:01