Joystick Mounting
From
Battery
ACC Wire
Shown here is typical Ignition connection, Your Ignition may vary but the function will not.
Cut Tractor Starter Wire to Starter Sole- noid and reroute through Joystick
Ignition
Tractor Ignition
Harness Brown
Supply to Joystick
wires.
Starter
"S"
Tractor
Ignition Switch
Tractor Ignition Terminal
1
Starter "S"
terminal
Interupt
2
|
| To Tractor Battery | |
| To Tractor | 12VDC (+ Pos) | |
|
| ||
| Starter "S" | To Tractor Battery | |
| terminal | ||
3 | 12VDC (- Neg.) | ||
Starter "S" | |||
| |||
| terminal |
|
Joystick Wiring Harness 
FIGURE 17
Interupt | 4 | 5 |
7.Connecting Harness Wires. There are 5 wires that must be connected to Tractor wiring, these wires will be marked with the description of what they are from the factory.
1.Power supply to joystick, this wire will be connected to the tractors ignition switch wire, as close to the ignition switch as possible. It is recommended to be not more that 3" away from ignition switch.
2.This is the tractor starter interrupt switch. It connects to the wire to the tractors starter solenoid marked "S", this prevents the tractor from being started when the mower is in the on position.
3.This is the return for the tractor starter interrupt switch. It is connect back into the other end of the cut starter solenoid wire.
4.Battery 12 VDC + connection which connects direct to the battery terminal. This wire will power a relay that will operate the electric cooling fan for the hydraulic oil.
5.Ground wire, This connect direct to the negative Battery terminal of the battery. It will serve as a ground for the system.
8.Reinstall Dash Panel. Reinstall any dash panels after the wires have been connected to the tractors wiring system if they were removed . Dash panels will vary with the type and model tractor used, the type fasteners will vary. Consult tractors manufacturer service repair and/or parts manual for removing any fasteners fro the tractor components. Note: All wires for the tractor connection with wire harness should all be under floor mat of tractor and not visible with the exception of the harness running up to the bottom of the joystick this will prevent damage to the wiring. (See Figure 18 & 19)
Axtreme Boom (Asy Man) 07/06
© 2006 Alamo Industrial | Section 9 - 8 |
