Pump - Driveline - Hose Installation
9.Tighten Clamp Yoke. After Gap between Yoke and Pump has been adjusted tighten the Bolts & Nuts on the Clamp Yoke (See Figure 9 & 10). Check Pump to Yoke Gap once more. Keep Pump Supported do not let it hang on Yoke.
10.Mount Pump to Pump Plate. Remove the Bar that is slid through the Driveshaft Yoke and push the Pump inward (See Figure 11). This will make the two piece Driveshaft slide together allowing the Pump to be pushed towards the tractor. Do this untill the Pump is against the Pump Plate (See Figure 12).
11.Install Pump Mounting Bolts. While holding in on the Pump (See Figure 12) start the two Pump Retaining Bolts. Make sure both Bolts are started well before you stop supporting pump. The Bolts should be snugged untill pump sits level before you stop supporting it (See Figure 12). Let go of the Pump, it may slide back some and leave a slight gap between Pump and Mounting Plate (See Figure 16).
Bar to Hold Driveshaft
Loosen
Clamp
Yoke Bolt
Figure 7
Align Splines of
Pump Shaft w/
Splines of Yoke
| Bar to Hold |
Figure 8 | Driveshaft |
|
|
Pump | 1/16" to 1/8" Gap | Splined | |
Assembly | Clamp | ||
between Pump & | |||
| Yoke | ||
| Yoke (must) | ||
|
| ||
Figure 9 |
|
|
Gap ? Check, this must have a gap
between Pump & drivesahft
Figure 10
Figure 11
Axtreme Boom (Asy Man) 07/06
© 2006 Alamo Industrial | Section 6 - 5 |