Valve Remote Cable Controls
Mechanical Remote Cable Controled Valve (Standard)
Door (Yellow / White) | Tilt (Red) | Dipper (Blue) | Lift (Orange / White) | Swing (Green / White) |
|
|
| Tilt (Red / White) | Dipper (Blue/ White) |
|
| Hoses have colored plastic ties |
|
| Door (Yellow) | Lift (Orange) | Swing (Green) | on them that match the colors | ||
| Figure 1 | listed here, this is a guide to | |||||
|
| which hose connects where | |||||
|
|
|
Cylinder Control Valve Cables To Valve Spools:
The Remote Control Cables Connection to the valve and the Control Handle assembly. See
Figure 2 for listing of items (1 thru 8 ) listed in assembly steps.
Remove the phillps head screws that are in the valve body next to the spool end (8). There are bolts in kit that will be used to replace these screws when needed (See Figure 2).
Slide the Bolt flange (8)
Place flange on sleeve and thread flange / sleeve assembly entire length of threaded hub and onto cable (2 & 6).
Place connector onto threaded rod and against jam nut. Align connector so it will mate with spool terminal and secure jam nut against connector (4).
Slide the connector onto spool and align the holes. Insert pin through connector and spool holes (5). The control cables will need to inserted through the floor of the tractor cab and the Control Levers will need to be assembled to the cables before continuing with the next assembly steps.
With cable attached to the valve and control levers, turn the flange / sleeve assembly onto the threaded hub until it is flush with the valve face. When turning the flange / sleeve assembly make certain that the control levers remains in the neutral position.
Tighten
Bring flange into position and bolt assembly to valve housing. Tighten screws sufficiently to flatten lockwashers / secure flange (8). Caution, overtightening flange bolts will distort flange.
Axtreme Boom (Asy Man) 07/06
© 2006 Alamo Industrial | Section 8- |
A | A | A | A | A | Pressure Supply (Port P1) |
1 | 1 | 2 | 2 | 2 | 3 |
| |||||
B | B | B | B | B234567 |
|