General Information / Installation Requirements
WARNING!
WARNING!
Use extreme care when moving, handling or adjusting the tractor tires. The tires are extremely heavy and could fall and crush you
Use an overhead crane or forklift to move the tires.
Properly fasten the tires to the material handling equipment to prevent the tire from falling.
The hydraulic oil is under high pressure and a hydrauli leak can cause oil to be injected under the skin.
Before starting the tractor ensure all hydraulic connections have bee tightened Never check for leaks with your hands. Use a piece of wood or cardboard to check for the leak making sure your hands and face are kept away from the leak area.
Repair any leaks before operating the equipments
Clean up all oil that has leaked according to the requirements of the oil supplier. Oil residue on the ground can result in unjury from slipping or falling.
TRACTOR PREPARATION (FIGURE 1 & 2)
1.Temporally remove ROPS and fenders from tractor axle. Move left rear tire out so that it is 50 inches from the outside of left rear tire to the center of tractor. Then move the right rear tire out so that it is 96 inches between the outside of the left and right rear tires. Refer to your tractor’s Operator’s Manual for instructions on Rear Wheel Adjustment for your particular tire. FIGURE 1. Hydraflate rear left tire as much as needed for stability but stay in
FIGURE 1
50"
96"
WARNING: Never operate the tractor with a loose wheel rim or disc. Always tighten nuts to the specified torque and at the recommended intervals.
2.Extend front wheels out so that it is 55" inches between the inside of the tires. This will allow no interference between tire and front mount bracket. FIGURE 2.
FIGURE 2
55"
Axtreme Boom (Asy. Man) 07/06
© 2006 Alamo Group Inc. | Section 3 - 5 |
