Joystick Mounting
FIGURE 18
Installing Wire Harness
To Valve:
1.Wire Harness From Cab to Front. The wire harness runs out the bottom of the Cab on the right hand side. Run harness along under RH cab of Tractor to the control valve (See Figure 21). Note the wire harness runs bottom of cab and near the exhaust from the Tractor to the Stack Valve to the front of the tractor. Make certain to tie the Harness or Hoses to the Tractor for protection.
2.Gaskets on Valve Terminals. There are 5 wire terminals on Valve,
3.Wire Harness Terminal Identification. The Wire Harness Terminal Plugs are marked in writing on the plug. Swing, Lift, Dipper, Tilt and Door terminal plugs (5 Total). The Valve terminals are in this same order starting at the input cap end and going toward the blank end.
4.Wire Harness Terminal Installation. You will need to feed wire harness under the fitting of hoses to valve. (See Figure 20 & 21) lay the Plugs out in the Order they are to be installed starting at the far end terminal.
FIGURE 19
FIGURE 20
FIGURE 21
Axtreme Boom (Asy Man) 07/06
© 2006 Alamo Industrial | Section 9 - 9 |