Fuel Tank Replacement
4.Install Pick Up Tube & Gauge Sending Unit in new Tank. (If Required, See Assembly Drawings
sent with unit) The Pickup gauge sending unit from the factory tank will be installed into the new tank. This is recommended to be done before mounting the new tank to the tractor (See Figure 13). The new tank will have a fuel capacity of 51 gallons.
5.Install the new mount brackets to the tractor frame. (If Required, See Assembly Drawings sent with unit) The tank mounting brackets will bolt to the tractor the same as the factory brackets that were removed. Make certain that the brackets are installed correctly, the front bracket will have 2 outer holes (same as the tank see Figure 11 & 13). The rear bracket will have 1 hole in the outer end (same as the tank, See Figure 12 & 13)
6.Install The new Fuel tank onto Tractor if required.(If Required, See Assembly Drawings sent with unit) The new fuel tank with the gauge sending unit slide in on top of the new mounting brackets with the fuel cap to the front (See Figure 14). Connect lines to fuel pick up connections, connect wiring to fuel gauge sending unit. (See Figure 14)
7.Bolt Tank to the Mounting Brackets.(If Re-
quired, See Assembly Drawings sent with unit) Bolt the tank to the mounting brackets, there are two bolts in the front bracket and one bolt in the rear bracket. (See Figure 15)
Front
Mounting
Tabs
Figure 13
Pick Up Tube Unit
Tank
Rear
8.Install New replacement Step.(If Required, See Assembly Drawings sent with unit) The new Replacement step is a bolt on weldment that will bolt to the new fuel tank with four bolts, note: below the step is painted yellow for clarity only (See Figure 16).
Rear
Bracket
(1 Bolt)
Front
Figure 15Bracket
(2 Bolts)
Figure 14
Figure 16
Axtreme Boom (Asy. | Man) 07/06 |
|
|
|
|
© 2006 Alamo Group Inc. | Section 4 - 5 |
|
