"ON - OFF" Switch Installation
Wiring Tractor with Remote Cable Cylinder Control Valve:
1.Connecting Harness Wires. There are 4 wires that must be connected inside Tractor. 1. Red Wire (power supply), 1 Black Wire (Ground) and 2 Brown Wires (Neutral Safety Switch). These will have to be spliced into Tractor circuits. (See Figure 15).
2. | Ground Wire. The Black |
wire at the harness (See Figure | |
15) can be connected inside the | |
cab floor, or it can be run down | |
through the floor and connected | |
to the frame below the cab. If | |
grounding to the Cab floor con- | |
nect ground now. |
Battery | Shown here is typical Ignition |
ACC Wire | connection, Your Ignition may |
| vary but the function will not. |
| Ignition |
3 | Reinstall Dash Panel. |
Reinstall the dash panel after | |
the wires have been connected |
Starter
Tractor | Ignition |
|
| Wire | |
|
|
to the tractors wiring system |
(See Figure 16 & 17) . The dash |
panel is attached with screw on |
fasteners. Note: All wires for the |
trator connection with wire |
harnes should all be under floor |
mat of tractor and not visible. |
this is a typical installation and |
will vaey from type tractor to |
tractor model. |
Tractor
Ignition Switch
Brown | Wire | |
Red | ||
|
Wiring
Harness
| Harness |
|
| of | Harness | ||
of |
| Harness |
| ||||
|
|
|
|
|
|
| |
Wire | of |
| Wire |
|
|
| |
| Brown |
|
|
| |||
|
|
|
|
|
| ||
|
|
|
|
|
| Wire | |
|
|
|
| Black | |||
|
|
|
|
|
| Cut Tractor Starter | ||
| Wire to Starter Sole- | ||
Ground | noid and | reroute | |
through | Joystick | ||
| |||
| Harness | Brown | |
| wires. |
|
FIGURE 15
FIGURE 16
FIGURE 17
Axtreme Boom (Asy Man) 07/06
© 2006 Alamo Industrial | Section 8- 10 |