Alesis QS8.1, QS7.1 manual Horn Level, Input Balance

Part 6: Editing Effects

Note: If you want to know how to control the speed of the Lezlie from the Mod Wheel or some other controller, learn about the Effects Mod function (button [60]). Also, see the note at the top of the Lezlie section regarding controlling Lezlie speed in the various Configurations.

HORN LEVEL

Range of Settings: -6 to +6 dB	Page 3	Config. 3
	Page 6	Config. 5

This parameter provides a way to cut or boost the high frequencies in the Lezlie effect, allowing you to “darken” or “brighten” the tone to suit your music. It works in 1dB increments, over a 12 dB range.

INPUT 1

Range of Settings: Reverb/Delay Page 1 Config. 5

In Configuration #5, as noted, the Lezlie has two possible input sources. This is one of them. It is limited to one of two settings: Reverb Output or Delay Output.

INPUT 2

Range of Settings: (see list below) Page 2 Config. 5

This parameter selects the second input to the Lezlie in Configuration #5. It has a wider selection of possible settings than Input 1. They are:

∙Sends 1 – 4

∙Overdrive Output

∙Pitch Input

∙Pitch Output

∙Delay Input

∙Reverb Input

INPUT BALANCE

Range of Settings: <99 to <0> to 99> Page 3 Config. 5 only

This controls the relative level of Input 1 and Input 2 signals going into the Lezlie.

When set to “<99”, only Input 1 is being routed to the Lezlie. When set to “99>”, all that goes through is Input 2 . When set dead-center to “<0>”, an even mix of both signals is passed on.

86 QS7.1/QS8.1 Reference Manual