Alesis QS7.1, QS8.1 manual Reverb Input Level Sends 2 Through, Range of Settings 00 to Sends 2

Part 6: Editing Effects

The next parameter is available on all other Configurations, but only on Sends 2 and 4 in Configuration #2:

REVERB INPUT LEVEL (SEND 1)

Range of Settings: 00 to 99 Page 4 (Config 1, 3, 4 and 5)

This parameter controls the overall Input Level going into the Reverb for Send 1. The signal it sends is based upon the Balance between the selected Inputs to the Reverb (if more than one Input was available).

REVERB INPUT LEVEL (SENDS 2 THROUGH 4)

Range of Settings: 00 to 99	Page 4	(Sends 2 and 3)
	Page 2	(Send 4)

This parameter controls the overall Input Level going into the Reverb for Sends 2 through 4. The signal it sends is based upon the Balance between the selected Inputs to the Reverb (if more than one Input was available).

Note: Naturally, Configuration #2 just had to be different. If it is the active Configuration and you press [10] to select Send 2 from within the Reverb function, you’ll wind up on page 1 and the display will look like this:

There is only one page available to you here. It lets you adjust the level of the signal going from Effect send 2 into the Reverb. Send 2 in this Configuration has no effects of its own, and is intended to be used for signals you want sent directly to Reverb 1 without running them through Delay 1 and Pitch 1 first.

Send 4 is similar to Send 2 in this Configuration, in that it has no effects of its own but serves as a bypass going directly to Reverb 3.

QS7.1/QS8.1 Reference Manual 97