Alesis QS8.1, QS7.1 manual Delay 00 to 99, Hold, Sustain Decay 00 to, Time Tracking On or Off

Part 8: Editing Programs

Delay (00 to 99, Hold) Page 5

This is the amount of time that the envelope will wait before doing anything; very useful if you want to affect one element of a sound sometime after the sound starts. When the Delay is set to 0, the envelope begins its attack segment right away, without any delay. Play some notes while turning up the delay and see that the time between playing the note and hearing the effect of the Pitch Envelope gets progressively longer as the Delay control is turned up.

If the Delay is set above 99, the display will read “Hold”. This indicates that the Delay stage of the envelope will wait indefinitely until the key is released before continuing on to the remaining envelope stages (Attack, Decay, etc.). With a value of “Hold”, the Pitch Envelope’s Trigger parameter is automatically set to “Freerun” in the software (see below). However, the displayed value of that parameter is not changed; only its behavior is.

Sustain Decay (00 to 99) Page 6

This is the amount of time that the envelope will take during the sustain stage to bring the level down to 0. If this is set to 99, the envelope will remain at the Sustain level until the note is released. When set to 0, the envelope’s level will immediately jump down to 0 upon reaching the sustain stage.

Trigger (Normal, Freerun, Reset, Reset-Freerun) Page 7

The Trigger mode determines how the envelope will function. You may select either Freerun or Reset, or both (Reset-Freerun) or neither (Normal). When set to Normal, the envelope will always start at its current level (i.e., if another note had been played which triggered the envelope’s cycle, playing another note in the middle would not interrupt the cycle). Also in Normal mode, the envelope will immediately advance to its release stage upon releasing the note. When set to Freerun, the envelope will complete its entire cycle, even if the note is released in the middle. When set to Reset, the envelope starts at the beginning whenever a new note is played. When set to Reset-Freerun, the envelope will start at the beginning whenever a new note is played and will complete its entire cycle, even if the note is released in the middle.

If a Sound layer’s Keyboard Mode parameter (found in the Pitch Function, Page 10) is set to “Mono”, the Pitch Envelope will only retrigger when playing legato if the Trigger Mode is set to either “Reset” or “Reset-Freerun”.

Time Tracking (On or Off) Page 8

This determines whether or not keyboard position will affect the cycle speed of the envelope. When turned on, playing toward the higher end of the keyboard will result in a faster envelope cycle; playing toward the lower end of the keyboard will result in a slower envelope cycle. However, this does not affect the attack time, but only the decay, sustain decay and release segments. This feature will result in only a subtle change. The envelope’s timing doubles or halves over a range of two octaves.

132 QS7.1/QS8.1 Reference Manual