Insert the SD memory card
2 Insert your SD memory card until it clicks.
Remove the SD memory card
2 Push the SD memory card that is inserted. The SD memory card is pulled out.
3 Close the cover of SD memory card slot.
4 Close the movable monitor.
Adjusting the Monitor Viewing Angle
Adjust the monitor’s angle for better visibility.

Inserting/Ejecting a Disc

1 Press on the unit.

The display changes to the Eject/Tilt screen.

2 Insert a disc:

Touch [Open] on the Eject/Tilt screen.

The movable monitor will open, then insert a disc into the disc slot. Inserting a disc will close the monitor automatically.

Disc Slot

Eject the disc:

Touch [Eject] of Disc on the Eject/Tilt screen.

The movable monitor will open. Then the disc is ejected. After remove the disc, touch [Close] to close the movable monitor.

Touching [Exit] returns to the earlier main source screen.

Do not apply shock to the movable monitor when it is open as it may result in malfunction of the unit.

The monitor may be dim during low temperature and immediately after turning on the power. The brightness will return to normal as time elapses.

The monitor will stop at the set tilt angle when closing.

CAUTION

Keep hands (or any other object) away from the monitor while it is opening or closing to avoid damage or injury. The back of the movable monitor will get very warm under normal operating conditions. This is not a malfunction. Do not touch.

1 Press on the unit.

The display changes to the Eject/Tilt screen.

2 Touch [] or [] of Tilt to adjust the desired monitor angle.

The monitor angle can be adjusted in 5 stages.

3 Touch [Exit] to return to the previous screen.

If the monitor touches an obstacle while the angle is being adjusted, it will stop immediately.

The screen color will vary when viewed at certain angles. Adjust the screen angle for the best viewing position.

If the voltage of the vehicle’s battery power is low, the screen may blink when the screen angle is changed. This is normal and not a malfunction.

Inserting/Removing the SD Memory Card (Only for Updating the Navigation System)

You can update the software and map of navigation system by using an optional SD memory card. To insert and take out the SD memory card, follow the instructions below.

1 After opening the movable monitor, open the cover of SD memory card slot.

Adjusting the Volume

Adjust the volume by pressing or .

Volume decreases/increases continuously by pressing and

holding or . Volume: 0 - 35

Lowering Volume Quickly

Activating the Audio Mute function will instantly lower the volume level by 20 dB.

Press MUTE to activate the MUTE mode.

The audio level will decrease by about 20 dB.

Pressing MUTE again will bring the audio back to its previous level.

18-EN

Page 18
Image 18
Alpine INA-W910 owner manual Inserting/Ejecting a Disc, Adjusting the Volume, Lowering Volume Quickly, 18-EN