Install the GPS antenna

<For inside vehicle>

1.Stick the ground pad at the center of dash board and close to windshield with one inch distance.

2.Attach GPS antenna to the center of ground pad. (the cable side faces the back of vehicle)

<For outside vehicle>

At the front or back of vehicle roof.

Wiring the GPS antenna cable

Do not bend or fold the GPS antenna cable.

When installing the INA-W910 to the vehicle, make sure the back of unit and the cable must not be bent.

Connect the GPS antenna

Securely connect the GPS antenna connector to INA-W910.

Connection of USB extension cable (included)

Connect the USB extension cable to the USB connector of the unit, and then secure the connection using the lock case supplied with USB extension cable as shown below.

INA-W910

USB Connector

Cable (Supplied)

Foot Brake Lead / Parking Brake Lead Connection

INA-W910

FOOT BRAKE

 

Foot brake lamp

 

 

 

Foot brake switch

(Yellow/Black)

Pinch

Foot brake lead

 

 

Connector

 

Chassis

PARKING BRAKE

(sold separately)

 

 

Parking brake lamp

Battery

 

Pinch

(Yellow/Blue)

 

 

 

Connector

Parking brake lead

Parking brake switch

 

(sold separately)

 

 

Connection Diagram of SPST Switch (sold separately)

(If the ACC power supply is not available)

INA-W910

 

FUSE (5A)

SPST SW (Optional)

(Optional)

IGNITION

 

(Red)

 

BATTERY

 

(Yellow)

FUSE (20A)

 

 

(Optional)

Battery

If your vehicle has no ACC power supply, add an SPST (Single-Pole, Single-Throw) switch (sold separately) and fuse (sold separately).

The diagram and the fuse amperage shown above are in the case when INA-W910 is used individually.

If the switched power (ignition) lead of the INA-W910 is connected directly to the positive (+) post of the vehicles battery, the INA-W910 draws some current (several hundred milliamperes) even when its switch is placed in the OFF position and the battery may be discharged.

To prevent external noise from entering the audio system.

Locate the unit and route the leads at least 10 cm away from the car harness.

Keep the battery power leads as far away from other leads as possible.

Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.

If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise suppressors, contact them for further information.

Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.

123-EN

Page 123
Image 123
Alpine INA-W910 owner manual 123-EN