Storing the Preset Dialing Number

Numbers that you dial frequently can be stored into a preset list for quick recall. Five numbers can be assigned as the preset dialing numbers. After setting, you can dial these numbers directly. About how to make a preset dialing, refer to “Dialing the preset number” (page 89).

1 Touch [ ] of the desired name on the Phone Book screen.

The stored numbers of the selected name is listed.

Display example for the number list screen

2 Touch the [Preset] of the number you want to assign as a preset dialing number.

A message will display to show you the preset NO. (1~ 5) of the assigned number.

If all the 5 positions have been used, you cannot assign the 6th number. To assign another number, you need to delete one of the preset number from position 1 to 5 first. About how to delete the preset number, refer to “Deleting the stored shortcut memory” on page 85.

Dialing the preset number

Display example for Telephone Menu screen

Touch any one of the preset buttons [P.SET 1] through [P.SET 5] that has a number stored to it on the Telephone Menu screen.

The stored preset number is dialed directly.

Auxiliary Device (Optional)

Operating Auxiliary Devices (Optional)

To operate your devices connected to the AUX terminals on the rear panel of INA-W910 (AUX1 mode) or to the iPod (V)/AUX Input Connector by using an optional AV/RCA interface cable (4-pole mini AV plug to 3-RCA) (AUX2 mode), follow the procedures described below.

WARNING

It is dangerous (and illegal in many states) for the driver to watch the Video while driving the vehicle. The driver may be distracted from looking ahead and an accident could occur.

Install the INA-W910 correctly so that the driver cannot watch Video unless the vehicle is stopped and the emergency brake is applied.

If the INA-W910 is not installed correctly, the driver will be able to watch the Video while driving the vehicle and may be distracted from looking ahead and cause an accident. The driver or other people could be severely injured.

To activate your auxiliary devices:

Your vehicle must be parked with the ignition key in the ACC or ON position. To do this, follow the procedure below.

1Bring your vehicle to a complete stop at a safe location. Engage the parking brake.

2Keep pushing the foot brake and release the parking brake once then engage it again.

3When the parking brake is engaged for the second time, release the foot brake.

For automatic transmission vehicles, place the transmission lever in the Park position.

Now, the locking system for the AUX mode operation has been released. Engaging the parking brake can reactivate the AUX mode, as long as the car’s ignition has not been turned off. It is not necessary to repeat the above procedure (1 through 3), of “To activate your auxiliary devices”.

Each time the ignition is turned OFF, perform the procedure of “To activate your auxiliary devices”.

If you try to activate the auxiliary device while driving, the display will show the warning-Picture off for your safety.

89-EN

Page 89
Image 89
Alpine INA-W910 owner manual Auxiliary Device Optional, Storing the Preset Dialing Number, Dialing the preset number, 89-EN