
4 Adjust the crossover to your preference.
Selecting the
Touch [ ] or [
] of Freq., then select the
The adjustable bandwidth differs depending on the speaker (channel).
4.2ch (FRONT/REAR/SUBW.) System
Setting contents: |
|
Low | 20 Hz~200Hz |
Mid (REAR) | 20 Hz~200Hz |
High (FRONT) | 20 Hz~200Hz |
Adjusting the Slope
Touch [] or [
] of Slope, then adjust the HPF or LPF slope.
Adjustable slope: FLAT,
Adjusting the Level
Touch [] or [
] of Level, then adjust the HPF or LPF level.
Adjustable output level:
5 Repeat steps 3 to 4 to make adjustment to the other bands.
2.2ch (3WAY) System
2.2ch (3WAY) System / (L+R)
Setting contents:
Low /
2.2ch (3WAY) System / (L/R)
Setting contents:
4 Adjust the crossover to your preference.
Selecting the
Touch [ ] or [
] of Freq., then select the
The adjustable bandwidth differs depending on the speaker (channel).
2.2ch (3WAY) System
Setting contents: |
|
Low / | 20 Hz~200 Hz |
20 Hz~20 kHz | |
High | (1 kHz~20 kHz)*1/(20 Hz~20 kHz)*2 |
*1 When Factory’s is selected, refer to “Setting the Response Slope for the High Range Speaker (TW Setup)” (page 72).
*2 When User’s is selected, refer to “Setting the Response Slope for the High Range Speaker (TW Setup)” (page 72).
74-EN
Adjusting the Level
Touch [] or [
] of Level, then adjust the HPF or LPF level.
Adjustable output level:
Adjusting the Slope
Touch [] or [
] of Slope, then adjust the HPF or LPF slope.
Adjustable slope: FLAT*,
*FLAT can be set for the HIGH slope only when User’s is selected in “Setting the Response Slope for the High Range Speaker (TW Setup)” (page 72). Depending on the response characteristics of the speaker, care should be taken when setting the response slope to FLAT, as speaker damage may result. With this unit, a message is displayed when the response slope for the high range speaker is set to FLAT.
5 Repeat steps 3 to 4 to make adjustment to the other bands.
•While adjusting the
•About the 2.2ch (3WAY)/4.2ch (FRONT/REAR/SUBW.) system You can switch the system mode with the 2.2ch (3WAY)/4.2ch (FRONT/REAR/SUBW.) switch on the
Storing Settings in the Memory
Adjustment or setting contents of
Contents that can be stored vary depends on the audio processor used.
1 Check whether the Defeat mode is off.
2 Touch [MEMORY] on the A.PROCESSOR list display.
3 Within 5 seconds, touch any one of the preset buttons [P.SET 1] through [P.SET 6] on the A.Processor list screen.
The setting contents are stored.
•The stored contents will not be deleted even when the battery power cord is detached.
•This operation cannot be performed when a typical equalizer setting (e.g. Pops) is selected in “Equalizer Presets
Calling up the Preset Memory
1 Check whether the Defeat mode is off.
2 Touch any one of the preset buttons [P.SET 1] through [P.SET 6] on the A.Processor list display to select the preset memory.
•It takes a few moments to call up the preset memory.