AMD 4.4.5 user manual Journal, 239

			AMD Confidential
User Manual				November 21st, 2008
GetConfig				Displays the current AMD-8111 configuration.
	A.7.15	EHC
	1 simnow> ehc.usage
	Automation Command			Description
log (enable disable) {mp}				Enables or disables Memory (m) and PCI Configuration
				(p) logging.
	A.7.16	Journal
	1 simnow> journal.usage
	Automation Command			Description
GetParam				Returns „Super Block Size‟, „Index Block Size‟, „Index
				Levels‟, „Disk Block Size‟ and „Maximum Disk Size‟.
SetParam <Super Block Size>
<Index Block Size> <Index				Sets journal parameters.
Levels> [ <Disk Block Size> ]
	A.7.17	CPU
	1 simnow> cpu.usage
	Automation Command			Description
LoadAnalyzer <analyzer_file>				Loads the analyzer „analyzer_file‟ with specified
[<args>]				arguments „args‟).
ShowAnalyzers				Shows all loaded analyzers.
EnableAnalyzer <num> <01>				Enables (1) or disables (0) analyzer specified by „num‟.
UnloadAnalyzer <num>				Unloads analyzer specified by „num‟.
MCAFault <bank>				Causes a generic MCA fault if GenerateMCAFault is
<GenerateMCAFault(01)> <Status				true (1) at specified Bank, AddressReg and status.
Reg> <Address Reg>

ProductFile <FileName>	Use product file to set fuses and configure CPU and
	Northbridge.
	Sets or disables and enables code generator settings and
CodeGen <command> <args>	options. Command must be one of the commands shown
	in Table 15-13.Args depends on the command
	parameter, see Table 15-13.
	This command is limited to showing a profile of blocks,
DumpProfile [<blocks-to-dump>]	without symbols, based on the current epoch. For more
	information please refer to Section A.7.17.1, “Profiling
	in SimNow”.

A.7.17.1 Profiling in SimNow™ Technology

Here is an example use of the profiling command and its output:

Appendix A 239