WARNING
Risk of explosion if the battery is removed and/or replaced by an incorrect type. Dispose of used batteries in accordance with your local environmental regulations.
If the iPBridge has been disconnected from power, recharging begins automatically when power is restored to the system. The battery is fully charged after 24 hours of continuous power application.
Ethernet interface
The four independent 100/1000 GbE RJ45 Ethernet data ports support IP v.4 in compliance with IEEE 802.3 GbE. Each may also be used for iPBridge management.
A separate 10/100 Ethernet RJ45 management port may be used for iPBridge management.
GbE cables must be at least CAT-5E certified for 1000 Mb/sec. use.
Fibre Channel interface
The two independent optical SFP 4-Gb Fibre Channel ports auto-negotiate to 1-, 2- or 4-Gigabit devices. They provide full support for direct connect for F-port fabric switches, Class 3 and intermix ANSI Fibre Channel specifications, PLDA, public loop login (NL-ports) and fabric connect (N-port) and full duplex transmissions.

1.1 ATTO iPBridge 2700R/D

The ATTO iPBridge 2700R/D is a 1-Gigabit Ethernet to Fibre Channel 1U full-rack bridge for high performance, cost effective solutions in enterprise environments.

The iPBridge 2700R/D includes a single power supply, four Ethernet data ports, an Ethernet management port, a serial management port and two Fibre Channel data ports. It includes a battery-backed Real-Time-Clock, and an IP Time client (RFC 1631 compliant).

Designed to fit into a 1U, full-rack enclosure, the iPBridge 2700R/D supports side mounting so it may be mounted into a standard 19-inch rack. The ports and AC power are accessed from the rear of the unit while LEDs showing port activity and status are in the front.

Dimensions

Width: 17 inches

Length: 8.94 inches

Height: 1.7 inches (1U)

Weight: 8 pounds

Environment

Operating temperature: 5-40°C external

Ambient air should not exceed 40°C. User- configurable thermal sensor for automatic shutdown. Default is 70°C

Cooling: air enters through the slots in the rear panel and exits through the blower on the far end of the rear panel.

Humidity: 10-90% non-condensing

Power

Power draw: 100-260 VAC@1.7-.7 amps. ATTO Technology, Inc. does not offer specific international power cords. The power inlet on the unit is a IEC320-C14. When selecting a cord, be sure it meets all national safety compliance requirements.

Battery-backed event log SRAM & Real-Time-

Clock: A rechargeable Lithium ion battery cell will hold the memory in a 512KB SRAM for up to 30 days.

3

Serial port

The RS-232 serial port provides support for remote monitoring and

management using a DB9

connector. The baud rate is

1

6

RX 2

programmable and preset at the

7

TX 3

8

factory to 11500.

4

9

GND 5

 

 

LED indicators

The LED indicators can be viewed from the connector side and the front side of the iPBridge 2700R/D. (See Exhibit 1.1-2)

ATTO Technology Inc. iPBridge Installation and Operation Manual

Page 12
Image 12
ATTO Technology 2700C operation manual Atto iPBridge 2700R/D